Why a King Bed Doesn't Fit Every 'Master' Bedroom in Today's New BTOs

A husband squeezing past a king mattress in a small BTO master bedroom while his wife measures

The word master does a lot of heavy lifting on an HDB floor plan. In a new 4-room flat the main bedroom is often around 11 to 12 square metres including the attached bathroom's wall, and a good part of that is taken up before you put anything in it. Couples come in wanting a king because the room is called the master, and then the numbers do not agree.

The problem: the bed fits, the room stops working

A king mattress in Singapore is 182cm wide by 190cm long. A queen is 152cm by 190cm. That 30cm difference sounds modest until you put it against a wall.

Say your main bedroom measures 3.2m by 3.5m. Put a king against the long wall and you have 138cm of width left over. Take out a 60cm deep wardrobe and you are down to 78cm, which is your entire walkway, and that is before a bedside table on either side.

Then there is the door. Most bedroom doors swing inward and need roughly 80cm of clear arc. If the bed corner sits inside that arc, the door catches the mattress. In our experience this is the thing that decides it far more often than the floor area does.

The third pinch is the wardrobe doors, which we cover separately. A swing door wardrobe opposite a king bed frequently cannot open fully.

Why it happens

Floor plans are drawn with furniture in them, and the furniture in the drawing is often generic and generously small. A bed symbol on a plan does not tell you whether it is a queen or a king, and it never shows the bedside tables.

The other reason is that people measure the room but not the obstructions. Air conditioner ledges, the bomb shelter wall in a common room, a recessed column, the bathroom door swing: each of these eats into usable rectangle in a way that a stated square metre figure hides completely.

What to do about it

Work backwards from the walkway, not the bed

Decide your minimum walking width first. Around 60cm down one side is workable if you rarely use that side, and 70 to 75cm is comfortable for both people. Subtract that from the room width, subtract the wardrobe depth, and whatever is left is the widest bed the room can take. If that number lands under 182cm, the answer is a queen, whatever the room is called.

Tape it out before you order

Masking tape on the floor, 182cm by 190cm, plus the wardrobe footprint and the door arc. Walk it. Open the imaginary door. Ten minutes of this settles the argument permanently. Our mattress guide lists the standard sizes so you can tape the right rectangle, and king size vs queen size bed goes through the comparison in more detail.

If the room is tight, spend the difference on the mattress rather than the size

A queen that lets you walk around the bed is a better bedroom than a king you have to shuffle past sideways. If you go queen, it is worth putting the attention into construction and cooling instead, since our nights are warm and a mattress that sleeps hot will bother you far more than 30cm of width ever would. Something like the Rucas Aurora Cool Ultimate Mattress is the sort of thing I mean. The full range sits in the mattress collection.

Check the route in as well as the room

A king mattress is a rigid 182cm panel. Before ordering, check the lift depth, the tightest corridor turn and the bedroom door opening. It is a separate problem from whether it fits the room, and it catches people who cleared the first hurdle.

Before you decide

  • Measure the main bedroom wall to wall, then subtract ledges, columns and the bathroom door swing.
  • Set your minimum walkway width on each side before choosing a bed size.
  • Tape the mattress footprint, the wardrobe footprint and the door arc onto the floor.
  • Open the bedroom door fully with the tape down and check nothing is in the way.
  • Decide whether you need bedside tables on both sides, and include them in the maths.
  • Confirm the delivery route can take the size you have chosen.

Questions people ask

What is the smallest master bedroom that takes a king?

There is no single number, because it depends on the wardrobe depth and the door position. As a rough guide you want at least 3.4m of usable width once the wardrobe is accounted for.

Can I use a super single for one side instead?

Two separate mattresses on one frame works for some couples and is easier to move in, but the join in the middle is something you should try before committing.

Does a low frame make a king feel more possible?

It helps the room feel more open visually, but it changes nothing about floor area. The walkway is still the walkway.

Send us a WhatsApp message with your bedroom dimensions and where the door and wardrobe sit, and we will tell you straight whether a king works in that room. Or bring the floor plan down to Boon Lay, Ang Mo Kio, Sims Drive or Changi and try both sizes lying down.

Have Questions About Furnishing Your Home?

Chat with us on WhatsApp